Stamp Ink Refill Instructions

step one Step One - Lock Position One:
  • Hold the stamp body with your fingers on the two lock buttons.
  • Slowly push the mechanism in towards the body about one inch.
  • While pushing, gently push in the red lock buttons until the polymer disc locks into place (lock position one).
step one Step Two - Change Cartridge:
  • Using your thumb, push the back of the ink cartridge forward so it pops out. Be careful not to push too hard, or it will fly out.
  • Insert the new ink cartridge (ink side down) into the slot until it clicks into place.
step one Step Three - Lock position two:
  • You need to clean the polymer disc before unlocking the body.
  • Hold the stamp body with your fingers on the two lock buttons.
  • Slowly push the mechanism all the way into the stamp body.
  • Gently push in the red lock buttons until it locks into place (lock position two).
  • Wipe the ink off the polymer disc (wet wipe or damp cloth).
  • Once clean, hold the stamp body and gently press the mechanism in towards the stamp body and release (don't hold the lock buttons).